Exporting Statistics

Statistics can be exported not only via the Dr.Web Agent component as well as by means of Dr.Web MailD, via Storage type. Both these options can be enabled simultaneously.

Please note that export of statistics via Dr.Web Agent is disabled by default.

When all statistics is exported via Dr.Web Agent, it either sends the data to Doctor Web statistics server (see the StatisticServerHost, StatisticServerPort and UUID parameters in the [StandaloneMode] section of Dr.Web Agent configuration file - %etc_dir/agent.conf), or sends it to the Dr.Web central protection server (corresponding settings can be found in the [EnterpriseMode] section of Dr.Web Agent configuration file agent.conf).

To enable statistics export via the Storage type at first, set Yes as an the ExportStat parameter value in the[Stat] section, then set a value for, at least, one of the following parameters in the [Stat] section and set the commands for the statistics export:

•ExportBlockObjectsStorage - list of objects to export statistics on blocked messages;

•ExportStatStorage - export of statistics on all messages, processed by Dr.Web for UNIX mail servers;

•ExportPluginStatStorage - export of statistics on messages processed by each plug-in.

For detailed description of each parameter specified above, refer to the [Stat] Section.

Please note that when statistics is exported via Dr.Web Agent, two types of statistics are formed and sent separately:

•Statistics on all detected and processed threats (viruses and other malicious objects);

•Statistics on processed messages and operations on them.

These two types of statistics are gathered separately. So, if an email message which contains 5 different infected objects was processed, statistics of the first type has 5 records (about actions applied to each object, for example - cure) and statistics of the second type has only one record (about an action applied to the whole message, for example - pass).