Dr.Web for Unix Internet gateways is compatible with
•Linux distributions that meet requirements listed in Compatibility with Linux Distributions;
•FreeBSD version 6.x and higher for Intel x86 and amd64 platform;
•Solaris version 10 for Intel x86 and amd64 platform.
|
Used platform must be fully compatible with x86 processor architecture in 32-bit or 64-bit modes. 64-bit systems must support 32-bit applications. The products, operating in FreeBSD 6.x, cannot be integrated with Dr.Web ESS 10. |
For example:
To enable support for 32-bit applications in systems based on Debian/Ubuntu Linux the libc6-i386 library must be installed, in systems based on ALT Linux - the i586-glibc-core library.
For successful operation of Dr.Web for Unix Internet gateways, it is required to:
•Install and run Dr.Web Daemon and anti-virus Dr.Web Engine version 6.0.2 or later.
•Install and run Squid version 3.0.STABLE1 or later, or SafeSquid version 3.0 or later.
•Installed Perl 5.8.0 or later for Dr.Web Updater.
Dr.Web for Unix Internet gateways hardware requirements are the same as requirements for the command line interface of the compatible operating system.
Installation requires 205 megabytes.
GUI installer of Dr.Web for Unix Internet gateways requires X Window System. Execution of interactive configuration script in graphical mode requires xterm or xvt terminal emulators.
In addition to that, the following packages must be installed in your system:
•base64
•unzip
•crond
For successful installation of Dr.Web for Unix Internet gateways in FreeBSD OS (version later than 8.0), the compat7x library is required.
Depending on the range of problems to be solved by Dr.Web for Unix Internet gateways and operational load, meeting additional hardware requirements can be necessary.