Interfaces Page

On this page you can select a rule set to use for filtering packets transmitted through different network interfaces installed on your computer.

For details on a certain option, click a corresponding item in the picture.  To get information on options available in other panes, click the necessary tab.

For details on a certain option, click a corresponding item in the picture.
To get information on options available in other panes, click the necessary tab.

To set rulesets for network interfaces

1.In the Dr.Web Firewall settings window, select Interfaces.
2.For an interface of interest, select the appropriate ruleset. If a ruleset does not exist, you can create a new set of packet filtering rules.
3.Click OK to save changes, or click Cancel to close the window without saving changes.

To list all available interfaces, click All. This opens a windows where you can select interfaces that should be listed in the table permanently. Active interfaces are listed in the table automatically.

To configure rules for interfaces, click Configure.