Installing from the Command Line

Once the installation program for the command line starts, the command prompt displays on the screen.

1.To start installation, enter Yes or Y in response to the “Do you want to continue?” request. To exit the installer, enter No or N. In this case, installation will be canceled.

2.After that, you need to review the terms of the Doctor Web License Agreement, displayed on the screen. Press ENTER to line down or SPACEBAR to page down the text. Note that options to line up or page up the License Agreement text are not available.

3.After you read the License Agreement text, you are prompted to accept the terms. Type Yes or Y if you accept the License agreement. If you refuse to accept them, type No or N. In the latter case, the installer automatically exits.

4.After you accept the terms of the License Agreement, installation of the Dr.Web for Linux components automatically starts. During the procedure, the information about the installation process (installation log), including the list of installed components, will be displayed on the screen.

5.After the installation completes successfully, the installer exits automatically. If an error occurs, a message describing the error is displayed and the installer exits.

6.To start working with the installed Dr.Web for Linux, run the product in one of the available ways.

If the installation process fails due to an error, resolve the problems that caused this error and start an installation procedure again.