Dr.Web Samba VFS SpIDer monitor is activated on attempt to open a shared resource on the server. When the monitor is initialized
•Dr.Web Samba VFS SpIDer checks versions of the interface and Samba server
•Dr.Web Samba VFS SpIDer reads its configuration file
(%etc_dir/smb_spider.conf by default)
•Dr.Web Samba VFS SpIDer starts monitoring file operations performed by the clients.
On the first and second steps, Dr.Web Samba VFS SpIDer outputs information to the system log (syslog). By default, the following values are used to configure syslogd :
SyslogFacility = Daemon
SyslogPriority = Info
It is recommended to starts the modules in the following order:
•Dr.Web Daemon
•Dr.Web Samba VFS SpIDer
To ensure optimal performance, grant Dr.Web Daemon with permissions to access shared resources.
|
If Dr.Web Daemon is running without read access (for scanning) or write access (for curing, removing files, etc.) to files on a shared resource, the component will operate in the remote scanning mode and receive necessary files via the socket. In this mode, performance is considerably reduced. Dr.Web Daemon cannot scan files size of which exceeds 2 GB; therefore, Dr.Web Samba VFS SpIDer does not send such files for scanning. |
