Additional Settings

On this page you can specify some advanced SpIDer Guard settings on the protected station.

The following advanced SpIDer Guard settings are available:

•Operation mode—defines one of the operation modes for SpIDer Guard on the station: via the Linux kernel module (LKM); using the fanotify system service; in auto mode, when the suitable operation mode detected automatically. It is recommended to specify the AUTO value.

•Log level—defines the log verbosity level that is used for SpIDer Guard messages logging.

•Logging method—defines the logging method for SpIDer Guard. The following values are allowed:

▫Auto—use the logging method which is defined in Dr.Web ConfigD settings for all components of the solution.

▫Syslog—use the syslog system service for SpIDer Guard messages logging. If you specify this method, you must also specify the value of Syslog facility parameter. It defines the label (or subsystem) which is used by syslog to save messages from SpIDer Guard.

▫Path—use the specified file to store SpIDer Guard log messages. If you select this method, you must also specify a path to the file in the Log file field.