Search Panel

The search panel locates at the top right part of Dr.Web Security Control Center and used to simplify searching for elements. The panel may find both groups and separate stations according to specified parameters.

To find a workstation or group of workstations

1.Select the search criterion in the drop-down list of the search panel:

•Station—to search stations by name,

•Organization—to search user groups that represent an organization,

•Station ID—to search stations by unique identifiers,

•Group ID—to search groups by unique identifiers,

•User ID—to search stations by user unique identifiers,

•User name—to search stations by user name on station,

•IP address—to search stations by IP address,

•MAC address—to search stations by MAC address,

•Hardware— to search stations by the name or category of hardware installed on the station,

•Software—to search stations by the name of software installed on the station.

•Configuration—to search stations by defined parameter values of anti-virus components installed on stations. When you select this criterion, the search panel opens with the following settings:

▫Component—in the drop-down list, select the name of anti-virus component in the settings of which the search will be performed. To make the components selection from the list easier, you can use the search: start entering the name into the component field, and the system automatically suggests variants containing the entered symbols.

▫Parameter—in the drop-down list, select the name of a parameter, values of which are available for the search. Parameters with the complex structure of allowable values are not available for the search.

▫Value—set the value of the parameter selected below. Depending on allowable values of a specific parameter, you will be supported with either the drop-down list with allowable values or the entry field to specify the values by a user via the keyboard.

To start searching by component parameters, click Search.

2.For all search criterion except the Configuration (see above), specify a parameter value to search. At this, you can set:

•specific string for full match with search value,

•a mask for search string: the * and ? symbols are allowed.

3.Press enter to start the search. Extended search panel and the anti-virus tree will be opened.

4.The search results contain a hierarchical list of elements according the search parameters.

•If you searched for a workstation, occurrence of the workstation in groups will be displayed.

•If no elements are found, the message Nothing found will be displayed in the empty hierarchical list.