Installing NAP Validator

Dr.Web NAP Validator checks health of anti-virus software on protected workstations. It is installed on the computer where a configured NAP server resides.

To install NAP Validator

1.Run the installation file. In the dialog window, select the language to use during install. Select English and click Next.

2.On the Welcome page of the InstallShield Wizard, click Next.

3.On the License Agreement page, read the agreement. To accept the agreement and proceed with the installation, select I accept the terms of the license agreement and click Next. To exit the wizard, click Cancel.

4.On the next page, specify Dr.Web Server IP Address and Port and click Next.

5.Click Install. The installation begins.

6.When installation completes, click Finish.

After you install Dr.Web NAP Validator, add Dr.Web Server to the trusted NAP servers group.

To add Dr.Web Server to the trusted NAP servers group

1.To open NAP server configuration component, run the nps.msc command.

2.In the Remediation Servers Group section, click Add.

3.In the dialog window, enter the name for the new remedial server and Dr.Web Server IP address.

4.Click OK to save changes.